Suzuki 800 Intruder Club & Forum A UK Site Dedicated To The Suzuki C800, VL800, VX800, M800, VZ800, VS800, C50, M50 Model Intruder / Boulevard / Marauder |
| | This week's mods | |
| | Author | Message |
---|
oldtom Member
| Subject: This week's mods Mon Nov 03, 2014 8:52 pm | |
| *Installed a relay under the seat. (There are two plastic tabs sticking up at 90 degrees from the battery tray. I drilled a hole on one tab and bolted in the relay). *Installed a 6 way fuse holder on the bracket inside the right plastic side panel and also a loose fit plastic box to hold all the negative return wires. - This was wired to the Battery negative.
*Wired the relay to the Battery Positive and to the fuse box and wired across the terminals on one side ( temporary until I can find something better).
*Crimped a male spade connector to a length of wire and connected the Positive Pin in the spare outlet in the headlamp shell to the under-seat relay as a trigger feed.
*Removed rubber hand-grips and installed Oxford Hot Grips:
*Remove the OE hand-grips and the plastic spacers / trim and throttle side 'O' ring. These are boxed in case I want to go back to original.
*I opted to cut (hacksaw) the threaded ends of the hot grips off and this enabled refitting the original weighted bar ends.
*The wiring causes a problem as the cables are always too long. I tucked the excess wiring under the Speedo housing so it looks neater than wrapping it in a bundle at the headstock.
*The "Hot grips" supply and negative wires were taken under the tank to a connector in the fuse box and to the adjacent earth-box.
Everything tested out O.K.
Next job is to wire in the Sat-Nav, but that's on hold until the cable arrives in the post. This too will be wired to the fuse box and earth box and like the hot grips will only get a live feed when the ignition is "on". | |
| | | yorky VIP Member
| Subject: Re: This week's mods Mon Nov 03, 2014 9:05 pm | |
| Nice job there Tom...you obviously know what you are doing.
I remember some years back fitting new hot grips and they were a bit too long and I needed to trim the end....next thing I am looking at some frayed wires I have managed to cut through....oh dear ...another set of grips needed ! | |
| | | simbo * Site Guru *
| Subject: Re: This week's mods Mon Nov 03, 2014 9:14 pm | |
| Sounds good Tom, Good idea cutting the ends off and using the stock Bar Weights Are your Heated Grips the ones with the "auto cut out" after ten mins? ,I have some on my bandit and wired them straight to the battery (permanent live) so I could switch them on five mins before going for a ride to pre warm, very little draw on the battery and switch themselves off if I forget or someone messes with them?. | |
| | | oldtom Member
| Subject: Re: This week's mods Mon Nov 03, 2014 9:26 pm | |
| "Oxford Cruiser Hot Grips", I think the code is, "OF697". | |
| | | peardrop3 Very Valued VIP Member
| Subject: Re: This week's mods Tue Nov 04, 2014 10:39 am | |
| Nice mod for this time of the year Tom! | |
| | | Sponsored content
| Subject: Re: This week's mods | |
| |
| | | | This week's mods | |
|
Similar topics | |
|
| Permissions in this forum: | You cannot reply to topics in this forum
| |
| |
| |
Slide Show | A random selection of suzuki800.com member bikes. |
Latest topics | » 12inch apes by Mbroom21 Tue Apr 16, 2024 12:54 pm
» Aye what's happenin'? by 717RedRumBob Fri Apr 12, 2024 6:50 am
» Handle bars rotation for comfort by Badger Thu Apr 11, 2024 1:20 pm
» Hello! by GregWidger Mon Apr 01, 2024 9:16 pm
» Hey to all by alongfortheride Tue Mar 26, 2024 9:41 pm
» Just saying hello as asked... plus a question. by SAM11206 Wed Mar 20, 2024 6:34 pm
» Hello! by Onigatudor Wed Mar 20, 2024 2:39 pm
» Choke plunger by flying1 Wed Mar 13, 2024 4:43 pm
» Hello intruder people by nano Tue Mar 05, 2024 2:19 pm
» Hi from North east England by Brianhuck Sat Mar 02, 2024 7:30 pm
» VX800 - Wiring issue colours & diagram? by Billybop90 Fri Mar 01, 2024 12:44 am
» Looking for a set of Leg wind deflectors for a C50 Boulivard. by Aikido789 Sat Feb 24, 2024 10:11 am
» Saying hello from Cheshire by bernard chaddock Wed Feb 21, 2024 4:58 pm
» ola de portugal by fabio almeida Tue Feb 20, 2024 9:28 am
» Hello from Texas by icoolwecool99@gmail.com Mon Feb 19, 2024 9:47 pm
» VX800 vacuum hose(s) 1996 by Billybop90 Fri Feb 16, 2024 7:16 pm
» Chrome Fender Tips - Volusia VL800, Boulevard C50T by SWEET Fri Feb 16, 2024 6:25 pm
» New to the site by VAI777 Tue Feb 13, 2024 3:32 pm
» oldies but goldies by redevil Tue Feb 13, 2024 10:59 am
» My new M800 by Urko Sun Feb 11, 2024 11:12 am
|
|